Battery groups › 24R

BCI battery group

Group 24R battery size

A BCI group 24R battery is at most 260 mm long, 173 mm wide and 229 mm tall (10.24 × 6.81 × 9.02 in), according to the Battery Council International group chart.

Group 24R260 × 173 × 229 mm
Group 24R260 × 173 mmGroup 22F241 × 175 mmGroup 22HF241 × 175 mm
BCI group 24R maximum footprint (length × width) to scale, next to group 22F and group 22HF. Source: BCI group size chart.
Maximum size260 × 173 × 229 mm
In inches10.24 × 6.81 × 9.02
Terminal typesA and A2
PolarityReversed (R): positive terminal on the opposite side from the base group
Cold cranking amps (OE range)585–585 A
JIS equivalents48D26L, 55D26L, 65D26L, 75D26L, 80D26L and 110D26L (BCI best fit)

Cars whose manuals point to group 24R

None of the owner's manuals this site has read so far print group 24R. Most Japanese and Korean makers print a case size or capacity instead of a BCI group, so the battery label on the car is the better guide.

Measuring for a group 24R

To take a group 24R, the tray needs at least 260 mm (10.24 in) of length and 173 mm (6.81 in) of width inside the hold-down, and 229 mm (9.02 in) of height below the hood or any bracket, with room left for the cable ends. These are BCI maximums: a real group 24R battery can be a few millimetres smaller, never larger. Original-equipment batteries in this group were rated from 585 to 585 cold cranking amps, so the right rating depends on the car; match or exceed the rating on the battery you are replacing.

Nearby sizes

GroupL × W × H (mm)Difference from 24R
24260 × 173 × 2250 mm length, 0 mm width, -4 mm height
152R260 × 173 × 2250 mm length, 0 mm width, -4 mm height
24H260 × 173 × 2380 mm length, 0 mm width, +9 mm height
24F273 × 173 × 229+13 mm length, 0 mm width, 0 mm height
46273 × 173 × 229+13 mm length, 0 mm width, 0 mm height

Positive numbers mean the other group is bigger than group 24R. A bigger case only fits if your tray and hold-down have that much spare room; measure inside the hold-down frame, not the old battery.

Fitting a group 24R

The group sets the case size, terminal position and hold-down. A battery from another group can only replace it when the length, width and height all fit the tray and the terminals land on the same sides. No other passenger-car group in the BCI chart has exactly the same case size and polarity. Use the tray fit checker to list every group that fits a measured space.

Source: Battery Council International, BCI Group Sizes (Oct 2023 PDF), page 6. Checked 2026-10-20.